When all the unboxing was complete, this was the condition of the trucks that came with the car. Not a great look. But the Protocraft wheel sets will be reused. The rest well see below.

I thought about using another Intermountain Truck with the wheels but chose to use a pair of RY Models Proto48 50 ton Bettendorf instead. Mostly because they were on the workbench.

Next, I took off the half of the bolster that remained on the car I noticed that there was no spring on the bolster screws. So I decided to add one. Of corse that meant the while installing the new trucks, one had to shoot into the air. No problem reach into the screw bin and replace it.

I checked the remaining bolster it wasn’t a 2 mm screw. It was a 2.2 mm which I don’t stock. I did find the missing screw after searching the area around the workbench.

Both bolsters showed some damage. Since it was basically the same damage reversed, I wonder if it was actually damage or just poor quality castings. I know what my thoughts are.

I shaved off the ridge on the bolster and then used the body washer from the RY Models trucks between the car and the truck. This placed the car at a good height for the couplers.

Here is the car with the trucks installed and the original wheels sitting on top. No they won’t be a load just forgot to take them off the car for the image.

I’m not all that impressed with the car. Besides the trucks I was disappointed with the deck on the car. Check out the edges of the deck in the next two photos.

I wanted to try one, but I don’t think I’m happy with the car. Who knows, maybe I’ll change out the trucks for a pair of Ow5 trucks and you will see it for sale on my table in Chicago next month.